My log reports ” Sign up using Facebook. Oh well it’s working with the r driver so it must be the right one. If it’s recognized and the module for it is loaded, then I would check link status with ethtool and if that shows a link detected and a speed negotiated, try to run “dhclient” on the interface from the command line and try to see if it tells you anything informative at that point. Join our community today! BB code is On.

Uploader: Dajas
Date Added: 14 August 2006
File Size: 19.33 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 80353
Price: Free* [*Free Regsitration Required]

Last used Ubuntu I dgee tested on a dgs fully patched and up-to-date Red Hat Enterprise Linux 4 system I actually used a clone for testing called CentOS 4which was a bit harder to get installed as D-Link’s technical support people both via e-mail and on the phone on multiple occasions were mostly clueless when it came to Linux support. VCG determines the connection speed of the network as well as the length of the cable.

Went to the D-Link site to get the latest drivers too. I loaded a couple different flavors and they detect there is a NIC but it won’t connect to the network. By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service. The D-Link Network Control is a useful application that is installed along with the Windows drivers that provides a number of “tab views” that allow you to control the card as well as provide insight into how your DGET is performing.


BB code is On. Lack of modern Linux distro support The most basic fundamental networking component is the network interface card NIC.

I untarred it and ran the ‘make all’ command and then when I ran 503t sk98lin.

Archives and Manuscripts at the Bodleian Library

That’s the most advice I can give without knowing what the above results are. Results 1 to 9 of 9.

Is there any switches or anything I should use? Running “dhclient” alone does not do anything. Is there a list of NICs that work with linux?

drivers – Is there a list of NICs that work with linux? – Unix & Linux Stack Exchange

Sign up using Facebook. The card’s external LED lights also visibly let you know at what speed the network is operating.

November 23rd, 9. Find More Posts by ve1drg. November 23rd, 5. Jarvis Frost 6 1. Help answer threads with 0 replies. In every case the D-Link Network Control application correctly determined the length and status of the cable as well as the connection speed. Originally Posted by ve1drg Well I went looking for the appropriate linhx s for this ethernet card and I did find one. At first glance I had thought that the minimum spec were a bit too minimal, but after testing I can verify that it will install on even a Mhz CPU system and much to my surprise work.


Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter.

This compensation may impact how and where products appear on this site including, for example, the order in which they appear. Bookmarks Bookmarks Digg del. As part of my testing, I connected Cat5, Cat5e and Cat6 cables of varying lengths to both Gigabit and Mbps switches.

By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies.

It looks like it tries and tries but never connects. Cable length can be an issue in some installations as there is a maximum effective operational distance of meters for a typical Cat5 cable.

At one time I thought that the r driver was what I needed, but changed my mind after further reading. Need help here on eithernet dlink DGE T.

November 23rd, 3. November 23rd, 2.